The Intake Air Temperature (IAT) sensor is mounted in the air intake duct. Disconnect the IAT sensor harness connector. Carefully grasp the sensor and with a twisting and pulling motion, remove the IAT sensor from air intake duct. To install, reverse removal procedure.
Home/Buick/Century/Buick Century VI (1997-2005)/Repair manual/Removal & Installation/Removal & Installation (3.4L & 3.8L)
Contents
Wiring diagrams Section: Removal & Installation- Air Induction Systems
- Boost Control Solenoid
- Removal & Installation (3.8L - VIN 1)
- Supercharger
- Removal (3.8L - VIN 1)
- Throttle Body
- Removal (3.1L & 3.4L)
- Removal (3.8L - VIN K)
- Powertrain Control Module
- Crankshaft Position Sensor
- Century & Regal
- Grand Prix
- Impala & Monte Carlo
- Remote Programming
- Off-Board Remote Programming Procedure
- Pass-Thru Procedure
- Off-Board Pass-Thru Procedure
- Removal (3.8L)
- Removal (3.1L & 3.4L - Ckp Sensor "A")
- Removal (3.1L - Ckp Sensor "B")
- Engine Coolant Temperature Sensor
- Heated Oxygen Sensor
- Removal & Installation (3.1L)
- Removal & Installation (3.4L & 3.8L)
- Removal & Installation (3.8L) Except W Body
- Removal (3.1L)
- Removal (3.4L)
- Evap Canister Purge Valve
- Evap Canister Vent Valve
- Cooling System Bleeding
- Fuel Systems
- Fuel System Pressure Release
- Removal (Quick-Connect Fitting - with Metal Collar)
- Removal (Quick-Connect Fitting - with Plastic Collar)
- Fuel Filler Tube
- Fuel Filter
- Fuel Level Sensor
- Fuel Rail & Injectors
- Removal (Century, Grand Prix & Regal)
- Removal (Impala & Monte Carlo)
- Fuel System Cleaning
- Fuel Tank
- Fuel Tank Draining
- Fuel Tank Pressure Sensor
- Throttle Body Cleaning Procedure
- Camshaft Position Sensor
- Removal & Installation (3.8L)
- Knock Sensor
- Removal (3.4L & 3.8L)
- EGR System Cleaning
- EGR Valve
- Removal & Installation (3.1L & 3.4L)
- Removal (3.8L - Inlet Pipe)
- Removal & Installation (3.8L - Outlet Pipe)
- Removal & Installation (3.8L - Inlet Pipe)
- Evap Canister
- Evap Canister Vent Solenoid
- Evap System Cleaning
- Inspection Procedure
- Cleaning Procedure
- Removal (3.8L - Century, Grand Prix & Regal)
- Removal (3.8L - Impala & Monte Carlo)
- Secondary Air Injection Shut-Off Valve
- Torque Specifications
- Abbreviations
- Accessories Control Systems
- Accessory Drive Belts
- Adjustments
- Airbag
- Anti-Lock/traction Control
- Application
- Automatic HVAC System
- Automatic Trans
- Axle Shafts
- Basic Trouble Shooting
- Body Electrical
- Brakes
- Cabin Air Filter
- Charging System
- Check Lists
- Communication Devices
- Computer Relearn
- Cooling Fan
- Cooling System (Mechanical)
- Cruise Control Systems
- Diagnostic Connector Locations
- Door Locks & Anti-Theft Systems
- Drive Cycles
- Driveline/axles
- DTC Index
- Electrical
- Electrical Component Locations
- Emission Applications
- Engine
- Engine Performance
- Entertainment Systems
- Exhaust
- Exterior Body Panels
- Exterior Lights
- Exterior/interior Trim
- Frames, Subframes & Crossmembers
- Fuses & Circuit Breakers
- Gauges & Instrument Panels
- Heated Glass/defoggers
- Hoist/jack
- Horns
- Identification
- Ignition Switch/steering Lock
- Manual & Power Steering
- Manual HVAC System
- MAP Guidelines
- Mechanical
- Mechanical - Hydraulic
- Memory Modules
- Metric Conversions
- Mode 6
- Oem General Information
- Removal & Installation
- Reset Procedures
- Restraints
- Restraints Control Systems
- Rpo Codes
- Seats
- Sensor Range Charts
- Specifications
- Starter
- Steering
- Sun Roof/t-Top/convertible Top
- Suspension Front
- Suspension Rear
- Testing & Diagnostics
- Theory & Operation
- Traction Control Disable
- Transmission
- Warning System
- Wheel & Tire System
- Wheel Alignment
- Wiper/washer Systems