Recommended Torque Values
Alternator bracket to timing case 40 Nm
Alternator to bracket 20 Nm
Bracket for front engine suspension to cylinder block 60 Nm
Bracket for front engine suspension to engine damping block 40 Nm
Camshaft sprocket to camshaft 25 Nm
Chain tensioner to timing case 50 Nm
Con - rod bearing cap to con - rod 45 Nm
Crankshaft bearing cover to cylinder block 110 Nm
Crankshaft pulley to crankshaft 120 Nm
Crankshaft pulley to hub of water pump 8 3) Nm
Crossmember to underbody 45 Nm
Cylinder head to cylinder block 60 3) 4) Nm + 90° to 100°
Cylinder head to timing case 25 Nm
Engine damping block to front axle body 40 Nm
Engine vibration damper to bracket for engine suspension 40 Nm
Engine vibration damper to front axle body bracket 22 Nm
Exhaust manifold to cylinder head 35 Nm
Exhaust pipe to exhaust manifold 40 Nm
Fastening nut for slider to propshaft 40 Nm
Flex plate to crankshaft 60 1) 2) Nm
Flywheel to crankshaft 60 1) 2) Nm + 30° + 15°
Fuel distributor pipe to intake manifold 8 Nm
Fuel lines to fuel distributor pipe 15 Nm
Inductive pulse pick -up to timing case 8 Nm
Injection valve adapter to intake manifold 6 Nm
Intake bridge to intake bridge bracket 10 Nm
Intake manifold support to cylinder head 20 Nm
Intake manifold support to intake manifold 20 Nm
Intake manifold to cylinder head 35 Nm
Oil drain screw to oil pan 45 Nm
Oil filter cartridge to timing case 15 Nm
Oil pan to cylinder block 5 1) Nm
Oil pressure switch to timing case 45 Nm
Propshaft to transmission (M 10) 50 3) Nm + 75° + 15°
Propshaft to transmission (M 1 2) 95 Nm
Rear engine damping block to crossmember 20 Nm
Reinforcement crossmember to vehicle underbody 45 Nm
Servo pump clip to servo pump 20 Nm
Servo pump to bracket 30 Nm
Small heat shield to vehicle underbody 20 Nm
Spark plugs in cylinder head 40 Nm
Stabilizer to front axle body 40 Nm
Starter to cylinder block 70 Nm
Thermostat housing to cylinder head 20 Nm
Timing case to cylinder block 15 Nm
Torsional vibration damper to crankshaft 220 Nm
Visco- fan to water pump 50 Nm
Water outlet connection to thermostat housing 8 Nm
Water pump to timing case 15 Nm
1) Bolt must be recut before reuse and inserted with Locking Compound 15 10 177 (90 167 347).
2) Use new bolts if micro-encapsulated.
3) Use new bolts.
4) Turn bolts a further 30° to 40° after 10 minutes.