Crank Drive, Cylinder Block
Flywheel
| Engine | 14 NV, 16 SV, C 16 NZ, E 16 NZ, X 16 SZ, C 16 NZ2, 18 SV, E 18 NVR, | ||
|---|---|---|---|
| C 18 NZ, 20 NE, C 20 NE, C 20 NEF, 20 SEH | |||
| Starter ring gear | Before fitting, heat ring gear to 180 °C to 230 °C | ||
| Lateral run-out | Permissible lateral run-out of installed starter ring gear to flywheel: | ||
| mm | 0.5 | ||
| Precision turning | Permissible removal of material in clutch disc lining surface area: | ||
| mm | 0.3 | ||
| In order to achieve the functional relationship again after removal of material, the same removal of material must take place on the fore part of the flywheel | |||
| (contact for clutch assembly). | |||
| Engine | 14 NV, 16 SV, C 16 NZ, E 16 NZ, | C 16 NZ2, 18 SV, E 18 NVR, C 18 NZ | |
| X 16 SZ | 20 NE, C 20 NE, C 20 NEF, 20 SEH | ||
| Dimension "A" mm | 2.0 to 2.2 | 2.1 to 2.2 | |
| .P. A712.tif | 4 | 6 | tiff;; |