DTC P0330: KNOCK SENSOR CIRCUIT (BANK 2) Jaguar S-type I

Note. Bank 1 is located on right side of engine. Bank 2 is located on left side of engine.

1. Turn ignition off. Inspect knock sensor for correct installation. For location (Схема №2)or (Схема №3). Repair as necessary and retest system. If knock sensor is installed correctly, go to next step.
2. Disconnect knock sensor harness connector. Measure resistance between knock sensor terminals. If resistance is 4.5-5.5 megohms, go to next step. If resistance not 4.5-5.5 megohms, replace knock sensor and retest system.
3. Disconnect PCM harness connectors. (Схема №5) Check continuity of White/Red wire between knock sensor harness connector and PCM harness connector PI-1 terminal No. 52. (Схема №6) If continuity exists, go to next step. If continuity does not exist, repair open in White/Red wire and retest system.
4. Check continuity between ground and knock sensor harness connector White/Red wire. If continuity exists, repair short to ground and retest system. If continuity does not exist, go to next step.
5. Check continuity of Gray/Red wire between knock sensor harness connector and PCM harness connector PI-1 terminal No. 43. If continuity exists, go to next step. If continuity does not exist, repair open in Gray/Red wire and retest system.
6. Check continuity between ground and knock sensor harness connector Gray/Red wire. If continuity exists, repair short to ground and retest system. If continuity does not exist, replace PCM and retest system.