DTC P0101: MAF Sensor Circuit Range/Performance Problem Honda Pilot II

Note. Before you troubleshoot, record all freeze data and any on-board snapshot, and review GENERAL TROUBLESHOOTING INFORMATION . If DTC P1128, P1129, P2228, and/or P2229 are stored at the same time as DTC P0101, troubleshoot those DTCs first, then recheck for DTC P0101.

1. Check for poor connections or damage to these parts: PCV hose Intake air resonator Air cleaner Purge (PCS) line Brake booster Brake booster hose Are the parts OK? YES - Go to step 2 . NO - Repair or replace the damaged parts, then go to step 15 .
2. Check for damage or looseness at the air duct in the air cleaner. Is it OK? YES - Go to step 3 . NO - Reconnect or replace the air duct in the air cleaner, then go to step 15 .
3. Check for a dirty air cleaner element. Is it dirty? YES - Replace the air cleaner element (see «AIR CLEANER ELEMENT INSPECTION/REPLACEMENT»(ref-333563-S38299951722009072100000) ), then go to step 15 . NO - Go to step 4 .
4. Turn the ignition switch to LOCK (0).
5. Turn the ignition switch to ON (II).
6. Check the MAF SENSOR in the DATA LIST with the HDS. Is there about 0.2 gm/s or 0.5 V? YES - Go to step 7 . NO - Go to step 13 .
7. Start the engine.
8. Vary the engine speed between 2, 000 rpm and 3, 000 rpm.
9. Check the MAF SENSOR in the DATA LIST with the HDS. Does the reading change? YES - Go to step 10 . NO - Go to step 13 .
10. Hold the engine speed at 3, 000 rpm without load (in P or N) until the radiator fan comes on, then let it idle.
11. Test-drive the vehicle for several minutes in the range of these recorded freeze data parameters: ENGINE SPEED VSS MAP SENSOR MAF SENSOR
12. Monitor the OBD STATUS for DTC P0101 in the DTCs MENU with the HDS. Does the HDS indicate FAILED? YES - Go to step 13 . NO - If the HDS indicates PASSED, intermittent failure, the system is OK at this time. Check for poor connections or loose terminals at the MAF sensor/IAT sensor and the PCM. If the HDS indicates NOT COMPLETED, go to step 11 and recheck.
13. Turn the ignition switch to LOCK (0).
14. Replace the MAF sensor/IAT sensor (see «MAP SENSOR REPLACEMENT»(ref-333558-S39288478812009072100000) ).
15. Turn the ignition switch to ON (II).
16. Reset the PCM with the HDS.
17. Do «PCM IDLE LEARN PROCEDURE»(ref-333561-S36442749152009072100000) .
18. Test-drive the vehicle for several minutes in the range of these recorded freeze data parameters: ENGINE SPEED VSS MAP SENSOR MAF SENSOR
19. Check for Pending or Confirmed DTCs with the HDS. Is DTC P0101 indicated? YES - Check for poor connections or loose terminals at the MAF sensor/IAT sensor and the PCM, then go to step 1 . NO - Go to step 20 .
20. Monitor the OBD STATUS for DTC P0101 in the DTCs MENU with the HDS. Does the HDS indicate PASSED? YES - Troubleshooting is complete. If any other Pending or Confirmed DTCs were indicated in step 19 , go to the indicated DTC's troubleshooting. • NO - If the HDS indicates FAILED, check for poor connections or loose terminals at the MAF sensor/IAT sensor and the PCM, then go to step 1 . If the HDS indicates NOT COMPLETED, go to step 18 .