DTC P0369: CMP Sensor Circuit Intermittent Interruption Honda Pilot II

Note. Before you troubleshoot, record all freeze data and any on-board snapshot, and review GENERAL TROUBLESHOOTING INFORMATION .

1. Turn the ignition switch to ON (II).
2. Clear the DTC with the HDS.
3. Start the engine, and let it idle for 10 seconds.
4. Check the CMP B NOISE in the DATA LIST with the HDS. Are 0 counts indicated? YES - Go to step 7 . NO - Go to step 5 .
5. Test-drive the vehicle for several minutes in the range of these recorded freeze data parameters: ENGINE SPEED VSS
6. Check the CMP B NOISE in the DATA LIST with the HDS. Are 0 counts indicated? YES - Go to step 7 . NO - Intermittent failure, the system is OK at this time. Check for poor connections or loose terminals at the CMP sensor and the PCM.
7. Check for poor connections or loose terminals at these locations: CMP sensor PCM Engine ground Body ground Are the connections and terminals OK ? YES - Go to step 8 . NO - Repair the connectors or terminals, then go to step 11 .
8. Check for damage to the front camshaft pulley (CMP sensor pulser plate) (see «CMP SENSOR REPLACEMENT»(ref-333558-S38974017152009072100000) ). Is the pulser plate damaged? YES - Replace the front camshaft pulley (CMP sensor pulser plate), then go to step 11 . NO - Go to step 9 .
9. Turn the ignition switch to LOCK (0).
10. Replace the CMP sensor (see «CMP SENSOR REPLACEMENT»(ref-333558-S38974017152009072100000) ).
11. Turn the ignition switch to ON (II).
12. Reset the PCM with the HDS.
13. Do «PCM IDLE LEARN PROCEDURE»(ref-333561-S36442749152009072100000) .
14. Start the engine, and let it idle for 10 seconds.
15. Check for Pending or Confirmed DTCs with the HDS. Is DTC P0369 indicated? YES - Check for poor connections or loose terminals at the CMP sensor and the PCM, then go to step 1 . NO - Troubleshooting is complete. If any other Pending or Confirmed DTCs are indicated, go to the indicated DTC's troubleshooting.