Home ReviewsRefund
Home/Honda/Pilot/Honda Pilot II (2008-2011)/Repair manual/Testing & Diagnostics/DTC P0111: IAT Sensor Circuit Range/Performance Problem
Contents Wiring diagrams Section: Testing & Diagnostics All sections

DTC P0111: IAT Sensor Circuit Range/Performance Problem Honda Pilot II

Testing & Diagnostics ~375 words

Note. Before you troubleshoot, record all freeze data and any on-board snapshot, and review GENERAL TROUBLESHOOTING INFORMATION .

  1. Check for poor connections or loose terminals at ECT sensor 1/2 and the MAF sensor/IAT sensor. Are the connections and terminals OK? YES - Go to step 2 . NO - Repair the connections or terminals, then go to step 15 .
  2. Replace the MAF sensor/IAT sensor (see «MAP SENSOR REPLACEMENT»(ref-333558-S39288478812009072100000) ).
  3. Allow the MAF sensor/IAT sensor to cool to ambient temperature.
  4. Note the ambient temperature.
  5. Connect the MAF sensor/IAT sensor to its 5P connector, but do not install the sensor onto the air cleaner.
  6. Turn the ignition switch to ON (II).
  7. Note the value of the IAT SENSOR quickly in the DATA LIST with the HDS.
  8. Compare the value of the IAT SENSOR to the ambient temperature. Does the value of the IAT SENSOR differ 5.4°F (3°C) or more? YES - Go to step 13 . NO - Go to step 9 .
  9. Disconnect the MAF sensor/IAT sensor from the 5P connector.
  10. Using a heat gun, blow hot air on the MAF sensor/IAT sensor for a few seconds. Do not apply the heat longer than a few seconds or you will damage the sensor.
  11. Connect the MAF sensor/IAT sensor to its 5P connector, but do not install the sensor onto the air cleaner.
  12. Check the IAT SENSOR in the DATA LIST with the HDS. Does the IAT SENSOR change 58°F (32°C) or more? YES - Intermittent failure, the system is OK at this time. Check for poor connections or loose terminals at the MAF sensor/IAT sensor and the PCM. • NO - Go to step 13 .
  13. Turn the ignition switch to LOCK (0).
  14. Replace the MAF sensor/IAT sensor (see «MAP SENSOR REPLACEMENT»(ref-333558-S39288478812009072100000) ).
  15. Turn the ignition switch to ON (II).
  16. Reset the PCM with the HDS.
  17. Do «PCM IDLE LEARN PROCEDURE»(ref-333561-S36442749152009072100000) .
  18. Check for Pending or Confirmed DTCs with the HDS. Is DTC P0111 indicated? YES - Check for poor connections or loose terminals at the MAF sensor/IAT sensor and the PCM, then go to step 1 . NO - Troubleshooting is complete. If any other Pending or Confirmed DTCs are indicated, go to the indicated DTC's troubleshooting.

More articles — Pgm-Fi System