Contents Wiring diagrams Section: Testing & Diagnostics All sections

DTC P0630: VIN Not Programmed or Mismatch Honda Crosstour I

Note. Before you troubleshoot, record all freeze data and any on-board snapshot, and review the general troubleshooting information (see GENERAL TROUBLESHOOTING INFORMATION (+). This DTC is stored only when the PCM does not have the VIN information of the vehicle. Use the HAS to input the missing VIN information.

  1. Turn the ignition switch to ON (II).
  2. Check the VIN with the HAS. Does the HAS show the vehicle's VIN? YES -Go to step 5 . NO -Go to next step.
  3. Input the VIN to the PCM with the HAS. Does the HAS show COMPLETE? YES -Go to step 5 . NO -Go to next step.
  4. Check for Pending or Confirmed DTCs with the HAS. Is DTC P062F indicated? YES -Go to the «DTC P062F TROUBLESHOOTING»(ref-360080-S19465338222010042600000) . NO -Go to step 9 .
  5. Clear the DTC with the HAS.
  6. Turn the ignition switch to LOCK (0).
  7. Turn the ignition switch to ON (II), and wait 5 seconds.
  8. Check for Pending or Confirmed DTCs with the HAS. Is DTC P0630 indicated? YES -Go to next step. NO -Intermittent failure, the system is OK at this time. If any other Pending or Confirmed DTCs are indicated, go to the indicated DTC's troubleshooting.
  9. Update the PCM if it does not have the latest software (see «PCM UPDATE»(ref-360080-S11980508702010042600000) (+) or substitute a known-good PCM (see «SUBSTITUTING THE PCM»(ref-360056-S32194616542010042600000) (+).
  10. Check for Pending or Confirmed DTCs with the HAS. Is DTC P0630 indicated? YES -If the PCM was updated, substitute a known-good PCM (see «SUBSTITUTING THE PCM»(ref-360056-S32194616542010042600000) (+) then recheck. If the PCM was substituted, go to step 1 . NO -If the PCM was updated, troubleshooting is complete. If the PCM was substituted, replace the original PCM (see «PCM REPLACEMENT»(ref-360080-S27881728262010042600000) (+). If any other Pending or Confirmed DTCs are indicated, go to the indicated DTC's troubleshooting.