Home ReviewsRefund Car not listed?
Home/Honda/Crosstour/Honda Crosstour I (2012-2012)/Repair manual/Testing & Diagnostics/DTC P0326: Knock Sensor Malfunction
Contents Wiring diagrams Section: Testing & Diagnostics All sections

DTC P0326: Knock Sensor Malfunction Honda Crosstour I

Testing & Diagnostics ~191 words

Note. Before you troubleshoot, record all freeze data and any on-board snapshot, and review the general troubleshooting information (see GENERAL TROUBLESHOOTING INFORMATION ).

  1. Remove the intake manifold (see «INTAKE MANIFOLD REMOVAL AND INSTALLATION»(ref-512902-S18459429352012110400000) ).
  2. Check the condition of knock sensor installation. Is the knock sensor installed correctly? YES -Replace the knock sensor (see «KNOCK SENSOR REPLACEMENT»(ref-512916-S01223741972012110400000) ), then go to step 3. NO -Install the knock sensor correctly (see «KNOCK SENSOR REPLACEMENT»(ref-512916-S01223741972012110400000) ), then go to step 3.
  3. Turn the ignition switch to ON (II).
  4. Reset the PCM with the HDS.
  5. Do the PCM idle learn procedure (see «PCM IDLE LEARN PROCEDURE»(ref-512915-S18881962312012110400000) ).
  6. Test-drive under these conditions: Engine coolant temperature (ECT SENSOR 1) above 158°F(70°C) Transmission in D Engine speed at 1, 850 rpm or more Drive 5 seconds minute or more
  7. Check for Pending or Confirmed DTCs with the HDS. Is DTC P0326 indicated? YES -Check for poor connections or loose terminals at the knock sensor and the PCM, then go to step 1 . NO -Troubleshooting is complete. If any other Pending or Confirmed DTCs are indicated, go to the indicated «DTC'S TROUBLESHOOTING»(ref-512916-S10431985942012110400000) .

More articles — Pgm-Fi System (4-CYL)