Roof: Maintenance Nissan Pathfinder III рестайлинг

MEMORY RESET PROCEDURE

1. Please observe the following instructions at confirming the sunroof operation. NOTE: Do not disconnect the electronic power while the sunroof is operating or within 5 seconds after the sunroof stops (to wipe-out the memory of lid position and operating friction).
2. Initialization of system should be conducted after the following conditions. When the battery has been disconnected or discharged. When the sunroof motor has been disconnected from power. When the sunroof motor is changed. When the sunroof does not operate normally (Incomplete initialization conditions).

DRAIN HOSES

Removal

Scheme 114

Scheme 115

1. Remove the headlining. Refer to " «REMOVAL AND INSTALLATION»(ref-519822-S39057959832012122900000) ".
2. Visually check the drain hoses for proper connections, damage or deterioration.
3. Remove each drain hose and check visually for damage, cracks or deterioration.
4. Pour water through the drain hose to check for damage. If any damage is found, replace the drain hose. Installation Installation is in the reverse order of removal.

Visually check sunroof lid seal for any damage, deterioration, or flattening.

1. In the case of leakage around glass lid assembly, close glass lid assembly and pour water around it to find the damaged or gaped portion.
2. If any damage is found, inspect and repair the body sealing surface, replace sunroof lid seal, or replace glass lid assembly as necessary. Refer to «SUNROOF LID SEAL»(ref-519840-S03283543002012122900000) or «GLASS LID ASSEMBLY»(ref-519840-S24110233702012122900000) procedures in this article, if replacement is necessary.