Home ReviewsRefund
Home/Mazda/3/Mazda 3 BL рестайлинг (2011-2013)/Repair manual/Automatic Trans/DTC P0706:00 [Transaxle range sensor range/performance prob…
Contents Section: Automatic Trans All sections

DTC P0706:00 [Transaxle range sensor range/performance problem] Mazda 3 BL рестайлинг

Automatic Trans
DTC P0706:00Transaxle range sensor range/performance problem
DETECTION CONDITIONUnder the following conditions, pattern identification error in switch condition of transaxle range sensors 1 to 4: Battery voltage is 8 V or more . Diagnostic support note The MIL illuminates if the TCM detects the above malfunction condition in two consecutive drive cycles or in one drive cycle while the DTC for the same malfunction has been stored in the TCM. The AT warning light illuminates if the TCM detects the above malfunction condition in two consecutive drive cycles or in one drive cycle while the DTC for the same malfunction has been stored in the TCM. PENDING CODE is available. FREEZE FRAME DATA is available. The DTC is stored in the TCM memory.
FAIL-SAFE FUNCTIONInhibits learning control. Inhibits manual mode. Inhibits neutral idle control. Inhibits AAS.
POSSIBLE CAUSETransaxle range sensor (built-into TCM) malfunction
SYSTEM WIRING DIAGRAM

More articles — On-Board Diagnostic - Automatic Transaxle [FW6A-EL]