OIL CHANGE REQUIRED INDICATOR RESET
Note. A change oil indicator is standard equipment on all instrument clusters. However, on vehicles manufactured for export markets, this indicator is electronically disabled. This indicator is located within the odometer/trip odometer Liquid Crystal Display (LCD) unit. The change oil indicator consists of cycling textual CHANGE and OIL messages which appear in place of the odometer/trip odometer information in the odometer LCD unit.
This vehicle is equipped with an engine oil change indicator system. The "Oil Change Required" message will flash in the EVIC display for approximately 10 seconds after a single chime has sounded, to indicate the next scheduled oil change interval. The engine oil change indicator system is duty cycle based, which means the engine oil change interval may fluctuate, dependent upon your personal driving style.
Unless reset, this message will continue to display each time you turn the ignition switch to the ON/RUN position. To turn off the message temporarily, press and release the MENU button. To reset the oil change indicator system (after performing the scheduled maintenance) refer to the following procedure.
- Turn the ignition switch to the ON position (Do not start the engine).
- Fully depress the accelerator pedal, slowly, three times within 10 seconds.
- Turn the ignition switch to the OFF/LOCK position.
Note. If the indicator message illuminates when you start the vehicle, the oil change indicator system did not reset. If necessary, repeat this procedure.
Scheme 194
The Remote Compass Module (RCM) (2) is a separate stand alone module mounted to the top side of the headliner (1) at the left rear of the vehicle. The RCM can be accessed by removing both quarter trim panels and the headliner molding, then carefully lowering the rear of the headliner at the D-pillar area.
If the compass position sensor (Remote Compass Module) is inoperative and requires replacement. Refer to MODULE, COMPASS, REMOVAL .