Interior Equipment (Coupe): Adjustments Audi S5 I facelift

DIGITAL COMPASS, CALIBRATING

It is Necessary to Calibrate the Digital Compass if

1. Compass directions are not correct
2. The letter "C" instead of a direction will appear or the display will be blank
3. A new Automatic Dimming Interior Rearview Mirror -Y7- is installed

The Digital Compass May Also Need to be Calibrated if

1. The vehicle battery was reconnected after being disconnected for an extended period
2. A new audio system or audio system component was installed

Digital Compass, Calibrating

Switch on ignition

1. The letter "C" must appear in the display -1

If the letter "C" does not appear, press the button -2- for 9 to 12 seconds until the "C" appears in the compass display.

Drive in a circle two to three times at about 10 km/h (5 mph) until a direction is shown in the compass display.

The interior rearview mirror automatic dimming function is reactivated after the calibration is complete. Ensure the interior rearview mirror automatic dimming function is activated. Refer to AUTOMATIC DIMMING FUNCTION, SWITCHING ON AND OFF .

Scheme 10

1. Interior Rearview Mirror Removing and installing, refer to «INTERIOR REARVIEW MIRROR»(ref-520128-S40453563282012123100000)
2. Retaining Spring
3. Rain/Light Recognition Sensor -G397- Removing and installing, refer to «Removal and Installation»(ref-520177-S21167214412012123100000)
4. Upper Cover
5. Retaining Plate Bonded to the windshield
6. Upper Cover
7. Electric Wire
8. Lower Cover

Scheme 11

1. Interior Rearview Mirror Removing and installing, refer to «INTERIOR REARVIEW MIRROR»(ref-520128-S40453563282012123100000)
2. Retaining Spring
3. Rain/Light Recognition Sensor -G397- Removing and installing, refer to «Removal and Installation»(ref-520177-S21167214412012123100000)
4. Upper Cover
5. Retaining Plate Bonded to the windshield
6. Electric Wire
7. Upper Cover
8. Lower Cover
9. Cover For the mirror base