Pressure Sensor/receiver Drier - Removal & Installation: Other Volvo S60 I

Pressure sensor, receiver drier (all other models, 2001-2009), replacing

Note. The illustrations in this service information are used for different model years and/or models. Some variation may occur. However, the essential information in the illustrations is always correct.

Scheme 717

Note. First read the instructions covering slow and fast leaks. See Oil air conditioning (A/C) system, filling .

Note. Always plug the pipes and connections when working on the climate control system.

Drain the refrigerant from the system. See Refrigerant, draining .

Raise the vehicle.

Remove the air baffle beneath the radiator assembly, 2 x screws (1), the 2 x catches (2).

Scheme 718

Remove

1. the connector
2. the pressure sensor.

Install pressure sensor

Install

1. the pressure sensor. See: «Summary of tightening torques for specific components»(ref-415410-S04672336852011081500000)
2. the connector.

Finishing

Note. For tightening torques, see: Tightening torque .

Fill with coolant and leak tracing

Vacuum pump the air conditioning (A/C) system. See: Vacuum pumping .

Fill the system. See: Refrigerant, filling .

Leak trace the system. See: Leak tracing, fluorescent tracing agent / UV lamp or: Leak tracing, electronic leak tracer .

Install air baffle

Install the 2 x M6 screws for the air baffle. Tighten.