Overhaul Automatic Transmission: Removal & Installation Subaru Forester SF рестайлинг

Automatic Transmission Assembly Removal & Installation

For removal and installation procedures for automatic transmission, see appropriate AUTOMATIC TRANSMISSION article.

Scheme 1157

1. Disconnect transmission harness connector from stay. NOTE: Lift-up lever behind connector and disconnect it from stay.
2. Disconnect the air breather hoses. (Scheme 1157): Disconnecting Air Breather Hoses

Scheme 1158

Scheme 1159

1. Install air breather hoses. (Scheme 1158): Installing Air Breather Hoses
2. Insert inhibitor switch and transmission connector into stay. (Scheme 1159): Inserting Inhibitor Switch & Transmission Connector

REMOVAL

The multi-plate clutch is removed in the same way that the extension case is removed. See REMOVAL .

INSTALLATION

The multi-plate clutch is installed in the same way that the extension case is installed. See INSTALLATION .

1. Install the drive plate and driven plate.
2. Insert the rear drive shaft into the center differential assembly.
3. Combine the transmission case with the extension case, and install the rear vehicle speed sensor. See «INSTALLATION»(ref-175724-S27829424232005042600000) .

Scheme 1160

Scheme 1161

1. Using a press, remove the revolution gear. (Scheme 1160): Removing Revolution Gear
2. Using a press, remove the front and rear side ball bearings and clutch hub. (Scheme 1161): Removing Front & Rear Side Ball Bearings - Removing Clutch Hub