Home ReviewsRefund
Home/Mazda/3/Mazda 3 BM (2013-2016)/Repair manual/Automatic Trans/DTC P0711:00 [TFT sensor range/performance problem]
Contents Wiring diagrams Section: Automatic Trans All sections

DTC P0711:00 [TFT sensor range/performance problem] Mazda 3 BM

Automatic Trans
DTC P0711:00TFT sensor range/performance problem
DETECTION CONDITIONUnder the following conditions, the ATF temperature is 40 °C {104 °F} or less : Certain period has elapsed since engine start. Battery voltage is 8 V or more . ECU internal temperature sensor related DTC is not recorded. Soaked for 6 hours or more . ECU internal temperature increases above specified temperature. Diagnostic support note The MIL illuminates if the TCM detects the above malfunction condition in two consecutive drive cycles or in one drive cycle while the DTC for the same malfunction has been stored in the TCM. The AT warning light illuminates if the TCM detects the above malfunction condition in two consecutive drive cycles or in one drive cycle while the DTC for the same malfunction has been stored in the TCM. PENDING CODE is available. FREEZE FRAME DATA is available. The DTC is stored in the TCM memory.
FAIL-SAFE FUNCTIONInhibits learning control. Inhibits neutral idle control.
POSSIBLE CAUSETFT sensor malfunction
SYSTEM WIRING DIAGRAM

More articles — On-Board Diagnostic - Automatic Transaxle [FW6A-EL]