DTC P0339: CKP Sensor Circuit Intermittent Interruption Honda S2000 AP2 рестайлинг

Note. Before you troubleshoot, record all freeze data and any on-board snapshot, and review the general troubleshooting information (see GENERAL TROUBLESHOOTING INFORMATION ).

1. Turn the ignition switch to ON (II).
2. Clear the DTC with the HDS.
3. Start the engine, and let it idle for 10 seconds.
4. Check the CKP NOISE in the DATA LIST with the HDS. Are 0 counts indicated? YES -Go to step 7 . NO -Go to step 5.
5. Test-drive the vehicle for several minutes in the range of these recorded freeze data parameters: ENGINE SPEED VSS
6. Check the CKP NOISE in the DATA LIST with the HDS. Are 0 counts indicated? YES -Go to step 7. NO -Intermittent failure, the system is OK at this time. Check for poor connections or loose terminals at the CKP sensor and the ECM.
7. Check for poor connections or loose terminals at these locations: CKP sensor ECM Engine ground Body ground Are the connections and terminals OK? YES -Go to step 8. NO -Repair the connections or the terminals, then go to step 11 .
8. Remove the cam chain case (see «CAM CHAIN REMOVAL»(ref-221322-S39532039912006022400000) ), then check the CKP sensor pulse plate for damage. Is the pulse plate damaged? YES -Replace the CKP sensor pulse plate (see «CKP PULSE PLATE REPLACEMENT»(ref-221322-S16953494212006022400000) ), then go to step 11 . NO -Go to step 9.
9. Turn the ignition switch to LOCK (0).
10. Replace the CKP sensor (see «CKP Sensor Replacement»(ref-351945-S11066940812009122900000) ).
11. Turn the ignition switch to ON (II).
12. Reset the ECM with the HDS.
13. Clear the CKP pattern with the HDS.
14. Do the ECM idle learn procedure (see «ECM IDLE LEARN PROCEDURE»(ref-221342-S09897997502006022400000) ).
15. Do the CKP pattern learn procedure (see «CRANK (CKP) PATTERN CLEAR/CRANK (CKP) PATTERN LEARN»(ref-221338-S21165415632006022400000) ).
16. Start the engine, and let it idle for 10 seconds.
17. Check for Temporary DTCs or DTCs with the HDS. Is DTC P0339 indicated? YES -Check for poor connections or loose terminals at the CKP sensor and the ECM, then go to step 1 . NO -Troubleshooting is complete. If any other Temporary DTCs or DTCs are indicated, go to the indicated DTC's troubleshooting.