Home/Honda/S2000/Honda S2000 AP2 рестайлинг (2003-2009)/Repair manual/Testing & Diagnostics/Fuel and Emissions Systems: Maintenance

Contents

Section: Testing & Diagnostics

Vtec

All sections

Fuel and Emissions Systems: Maintenance Honda S2000 AP2 рестайлинг

Testing & Diagnostics 1 illustration ~128 words

ECM Reset

Reset the ECM with the HDS while the engine is stopped.
Turn the ignition switch OFF.
Turn the ignition switch ON (II), and wait 30 seconds.
Turn the ignition switch OFF, and disconnect the HDS from the DLC.
Do the ECM idle learn procedure (see «ECM IDLE LEARN PROCEDURE»(ref-221342-S09897997502006022400000) ).

Scheme 4

Scheme 4: Clear/Learn Procedure (with the HDS)

Scheme 4: Clear/Learn Procedure (with the HDS)

Connect the HDS to the data link connector (DLC) (A) located behind the driver's side of the front console.
Turn the ignition switch ON (II).
Make sure the HDS communicates with the ECM. If it doesn't, go to the DLC circuit troubleshooting (see «DLC CIRCUIT TROUBLESHOOTING»(ref-351945-S34342936082009122900000) ).
Select CRANK PATTERN in the ADJUSTMENT MENU with the HDS.
Select CRANK PATTERN LEARNING with the HDS, and follow the screen prompts.