Home ReviewsRefund Car not listed?
Home/Honda/CR-V/Honda CR-V I (1995-1999)/Repair manual/Testing & Diagnostics/DTC P0113: INTAKE AIR TEMPERATURE (IAT) SENSOR HIGH VOLTAGE…
Contents Wiring diagrams Section: Testing & Diagnostics All sections

DTC P0113: INTAKE AIR TEMPERATURE (IAT) SENSOR HIGH VOLTAGE INPUT Honda CR-V I

Testing & Diagnostics ~173 words
  1. Turn ignition on. Check IAT sensor using scan tool. If -4°F (-20°C) or less is indicated, go to next step. If -4°F (-20°C) or less is not indicated, problem is intermittent. Check for poor connections or loose wires at IAT sensor connector and PCM connector. See the «WIRING DIAGRAMS»(ref-16319) article.
  2. Disconnect IAT 2-pin connector. Install jumper wire between IAT sensor connector terminals. Using scan tool, check intake air temperature. If -4°F (-20°C) or less is indicated, go to next step. If -4°F(-20°C) or less is not indicated, replace IAT sensor.
  3. Turn ignition off. Connect jumper wire between PCM 16-pin connector "D" terminal D8 and terminal D11. (Схема №2) Turn ignition on. Using scan tool, check intake air temperature. If -4°F(-20°C) or less is not indicated, repair open in wiring between IAT sensor and PCM connector "D". See the «WIRING DIAGRAMS»(ref-16319) article. If -4°F (-20°C) or less is indicated, substitute a known-good PCM and recheck. If symptom or indication goes away, replace original PCM.

More articles — Engine Controls - Tests W/codes - 2.0L