Home ReviewsRefund Car not listed?
Home/Honda/CR-V/Honda CR-V I (1995-1999)/Repair manual/Testing & Diagnostics/DTC P0112: INTAKE AIR TEMPERATURE (IAT) SENSOR LOW VOLTAGE …
Contents Wiring diagrams Section: Testing & Diagnostics All sections

DTC P0112: INTAKE AIR TEMPERATURE (IAT) SENSOR LOW VOLTAGE INPUT Honda CR-V I

Testing & Diagnostics ~193 words
  1. Turn ignition on. Check IAT sensor using scan tool. If 302°F (150°C) or more is displayed, go to next step. If 302°F (150°C) or more is not displayed, check if ambient air temperature is displayed. If engine is warm, displayed temperature will be higher than ambient air temperature. If ambient air temperature is not displayed, replace IAT sensor. If ambient air temperature is displayed, failure is intermittent. Check for poor connections or loose wires at IAT sensor connector and PCM connector. See the «WIRING DIAGRAMS»(ref-16319) article.
  2. Disconnect IAT sensor. Check IAT sensor using scan tool. If 302°F (150°C) or more is displayed, go to next step. If 302°F (150°C) or more is not displayed, replace IAT sensor.
  3. Turn ignition off. Disconnect PCM 16-pin connector "D". (Схема №2) Check for continuity between IAT sensor connector terminal No. 2 (Red/Yellow wire) and ground. If continuity exists, repair short in wiring between IAT sensor and PCM connector terminal D8 (Red/Yellow wire). See the «WIRING DIAGRAMS»(ref-16319) article. If continuity does not exist, substitute a known-good PCM and recheck. If symptom or indication goes away, replace original PCM.

More articles — Engine Controls - Tests W/codes - 2.0L