FASTENER TIGHTENING SPECIFICATIONS
| Component | Bolt Size | Nm |
|---|---|---|
| Air Conditioner (A/C) Compressor | 25 | |
| Bearing Cap | 65 + 90° | |
| Belt Pulley for the Ribbed Belt 1 | 20 + 90° | |
| Connecting Rod Bolt 1 | 30 + 90° | |
| Crankshaft Toothed Belt Sprocket 1 | 90 + 90° | |
| Dual-Mass Flywheel/Drive Plate 1 | 60 + 90° | |
| Generator | 23 | |
| Pressure Relief Valve | 27 | |
| Ribbed Belt Tensioning Damper | 23 | |
| Sensor Wheel 1 | 10 + 90° | |
| 1 Replace | ||
Accessory Assembly Bracket Tightening Sequence
Install bolts -1 through 6- and tighten by hand.
Tighten bolts -1 through 6- to 40 Nm.
Tightening Sequence of Front Sealing Flange
1. Install bolts -1 to 10- and tighten by hand.
2. Tighten the bolts -1 to 6- in a diagonal sequence in stages to 15 Nm.
3. Tighten bolts -7 to 10- to 15 Nm.
Rear Tightening Sequence
1. Install bolts -1 to 8- and tighten by hand.
2. Tighten the bolts -1 to 6- in a diagonal sequence in stages to 15 Nm.
3. Tighten bolts -7 to 8- to 15 Nm.
See also:
• Removal and Installation