Camshaft Adjustment Valve 1 -N205
Special tools and workshop equipment required
- Ratchet Insert 1/4" -VAS 6234
- TORX R Bit Set -V.A.G 1766
- Spring Type Clip Pliers -VAS 5024 A
- Torque Wrench (5-60 Nm) -V.A.G 1783
Removing
Disconnect the connector -1-.
Scheme 127
Loosen the wiring harness -2- from the bracket.
Remove the bolt -3-.
Note. Do not pull out the camshaft adjustment valve 1 by the connector.
Remove the bolts -arrows- and pull the camshaft adjustment valve 1 out of the housing.
Scheme 128
Installing
Note. The camshaft adjustment valve 1 as well as the housing must be free of dirt and contaminants. Remove the new camshaft adjustment valve 1 from is packaging only prior to installation.
| CAUTION | The camshaft adjustment valve 1 must not be subjected to knocks and impacts. |
Lubricate the seal with engine oil.
Carefully insert the camshaft adjustment valve 1 into the housing and press it perpendicular to the valve axis in by hand until it is seated.
Tighten the bolts to 4 Nm.
Further installation is in reverse order of removal.