FASTENER TIGHTENING SPECIFICATIONS
| Component | Fastener Size | Nm |
|---|
| Air Conditioning Compressor to Accessory Bracket Bolt | | 25 |
| Belt Tensioner to Accessory Bracket Bolt | | 23 |
| Camshaft Sprocket to Camshaft Bolt | | 50 + 180° |
| Connecting Rod Bearing Cap to Connecting Rod Bolt (1) | | 30 + 90° |
| Coolant Pump to Cylinder Block Bolt | | 15 |
| Coolant Thermostat Housing to Cylinder Block Bolt | | 15 |
| Crankshaft Bearing Cap to Cylinder Block Bolt (1) | | 65 + 90° |
| Crankshaft Toothed Belt Gear to Crankshaft Bolt (1) | | 90 + 90° |
| Engine Mount Bracket to Cylinder Block Bolt | | 45 |
| Engine Speed Sensor Bolt | | 10 |
| Flywheel/Drive Plate to Crankshaft Bolt (1) | | 60 + 90° |
| Generator to Accessory Bracket Bolt | | 23 |
| Generator to Accessory Bracket Bolt Nut | | 23 |
| Idler Roller to Cylinder Head Bolt | | 25 |
| Idler Roller to Sealing Flange Bolt | | 35 |
| Knock Sensor to Cylinder Block Bolt (3) | | 20 |
| Lower Toothed Belt Guard to Cylinder Block Bolt | | 8 |
| Oil Filter Bracket to Cylinder Block Bolt (1) | | 15 + 90° |
| Oil Spray Jet to Cylinder Block Bolt (with Pressure Relief Valve) | | 27 |
| Rear Toothed Belt Guard to Cylinder Head Bolt (2) | | 10 |
| Sealing Flange to Cylinder Block Bolt | | 15 |
| Sensor Wheel to Crankshaft Screw (1) | | 10 + 90° |
| Toothed Belt Tensioner to Cylinder Head Nut | | 25 |
| Upper Toothed Belt Guard to Cylinder Head Bolt | | 10 |
| Vibration Damper Pulley to Crankshaft Bolt (1) | | 20 + 90° |
| (1) Always replace (2) Install using locking fluid (3) Tightening specification affects the function of the knock sensor |
| (2) | Install using locking fluid |
| (3) | Tightening specification affects the function of the knock sensor |
Accessory Bracket Bolt Tightening Sequence and Specification
Tighten the accessory bracket bolts in the sequence shown to 40 Nm.
