Procedure Chart (1 Of 2). Scheme 712
Procedure Chart (2 Of 2). Scheme 713
OPERATION OF SHIFT SELECT LEVER
Make sure there is no abnormal noise, dragging or contact pattern in each select lever range.
| WARNING | Stop the engine while checking operation of selector level. |
Checking Operation Of Shift Select Lever. Scheme 714
Identifying Special Tools. Scheme 715
General Purpose Tools Chart. Scheme 716
Locating Sensor (1 Of 2). Scheme 719
Locating Sensor (2 Of 2). Scheme 720
Locating Solenoids. Scheme 721
Transmission Control Module (TCM) - I/O Signal (1 Of 4). Scheme 722
Transmission Control Module (TCM) - I/O Signal (2 Of 4). Scheme 723
Transmission Control Module (TCM) - I/O Signal (3 Of 4). Scheme 724
Transmission Control Module (TCM) - I/O Signal (4 Of 4). Scheme 725
Transmission Control Module (TCM) - I/O Signal (1 Of 4). Scheme 726
Transmission Control Module (TCM) - I/O Signal (2 Of 3). Scheme 727
Transmission Control Module (TCM) - I/O Signal (3 Of 4). Scheme 728
Transmission Control Module (TCM) - I/O Signal (4 Of 4). Scheme 729
Schematic Diagram (Without VDC System). Scheme 730
Schematic Diagram (With VDC System). Scheme 731
OPERATION
Raise the vehicle using a garage jack and place on safety stands or drive the vehicle onto free rollers.
| WARNING | Before raising the vehicle, ensure parking brakes are applied. Do not use a pantograph jack in place of a safety stand. Secure a rope or wire to the front and rear towing or tie-down hooks to prevent the lateral runout of front wheels. Do not abruptly depress/release clutch pedal or accelerator pedal during works even when engine is operating at low speeds since this may cause vehicle to jump off free rollers. In order to prevent the vehicle from slipping due to vibration, do not place any wooden blocks or similar items between the safety stands and the vehicle. Since the rear wheels will also rotate, do not place anything near them. Also, make sure that nobody goes in front of the vehicle. |
