Multi Info Display MID F2: TROUBLE CODE TABLE
| Trouble Code | Information Sensor |
|---|---|
| Cause of Fault | Remedy in |
F0: DATA LIST
| No. | Trouble Code Storage when... |
42
| AUTOMATIC TRANS. INFO. CIRCUIT |
|---|
| 07 |
| · The MID control unit does not recognize the voltage signal from the AT control unit for min. 2, max. 4 s at the "AT telltale" input. |
· The fault is recognized 6 s after ignition ON
Note:
The switch - on monitoring is only evaluated if the battery voltage measured is greater than 8 volts