Interior Backlighting Malfunction Opel GT II

Interior Backlighting Malfunction

Diagnostic Instructions

Diagnostic Fault Information

Circuit/system Description

The body control module (BCM) receives an input from the instrument panel (I/P) dimmer switch. The BCM provides the I/P dimmer switch with battery voltage and a low reference. The I/P dimmer switch is a potentiometer that varies the input signal voltage to the BCM. This input determines the intensity level of the backlighting illumination. The driver may change intensity of the backlighting by positioning the I/P dimmer switch between the minimum and maximum settings. The BCM will default to full intensity if the input from the I/P dimmer switch is not within the specified values. The backlighting illumination intensity is controlled by the BCM by varying the pulse width modulation (PWM) voltage that feeds the dimming signal circuits of the individual lamps. All interior backlighting lamps are permanently grounded.

Reference Information

Schematic Reference

Interior Lights Dimming Schematics

Connector End View Reference

Component Connector End Views

Description and Operation

Interior Lighting Systems Description and Operation

Electrical Information Reference (Except Opel Gt)

Scan Tool Reference

Control Module References for scan tool information

Circuit/system Verification

Ignition ON, observe the scan tool IP Dimmer Switch parameter while activating the switch from min to max. The voltage parameter should change as the switch is cycled between the min and max settings.

Circuit/system Testing

Interior Backlighting Malfunction

1. Ignition ON, install a scan tool and observe the Interior Light Dimmed Command parameter while turning the parks lamps ON and OFF. The reading should change between Off and On.
2. Ignition OFF, disconnect the harness connector at the component with the inoperative backlighting.
3. Ignition OFF, verify that a test lamp illuminates between B+ and the ground circuit.
4. Connect a test lamp between the instrument panel lamp supply control circuit that supplies the inoperative component lamp and ground.
5. Command the park lamps ON and OFF with the park lamps switch. The test lamp should turn ON and OFF when changing between the commanded states.
6. If all circuits test normal, test or replace the component with the inoperative backlighting.

Dimmer Switch Malfunction

1. Ignition OFF, disconnect the harness connector at the I/P dimmer switch.
2. Ignition OFF, verify that a test lamp illuminates between B+ and the low reference circuit terminal B.
3. Ignition ON, verify the scan tool I/P Dimmer Switch parameter is greater than 12 volts.
4. Install a 3A fused jumper wire between the signal circuit terminal C and the low reference circuit terminal B. Verify the scan tool I/P dimmer switch is less than 11 volts.
5. If all circuits test normal, test or replace the I/P dimmer switch.

Repair Instructions

Perform the Diagnostic Repair Verification after completing the diagnostic procedure.