DTC b2555
Diagnostic Instructions
| • | Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. |
| • | Review Strategy Based Diagnosis for an overview of the diagnostic approach. |
| • | Diagnostic Procedure Instructions provides an overview of each diagnostic category. |
DTC Descriptor
Passenger Compartment Lamp Control Circuit Open or Short to Battery
Diagnostic Fault Information
| Circuit | Short to Ground | Open/High Resistance | Short to Voltage | Signal Performance |
|---|
| Courtesy Lamp Control | 1 | B2555 05 | B2555 05 | -- |
| Inside Rearview Mirror Lamps Control | B1480 00 | 1 | -- | -- |
| Inadvertent Relay Control | 1 | 1 | -- | -- |
| Inside Rearview Mirror Ground | -- | 1 | -- | -- |
| 1. Courtesy Lamps Malfunction |
Circuit/system Description
The INT LIGHT fuse supplies battery voltage to the inadvertent load control relay located in the body control module (BCM). The BCM applies ground to the inadvertent relay control circuit which energizes the inadvertent load control relay coil. With the relay coil energized, the switch contacts close allowing battery voltage to flow from the INT LIGHT fuse to the inside rearview mirror lamps through the inside rearview mirror lamps supply voltage circuit. The inside rearview mirror lamps are controlled by a 3 position (OFF, DOOR, ON) switch. When the inside rearview mirror switch is placed in the DOOR position, the lamps are controlled by the BCM by grounding the courtesy lamp control circuit. When any door is opened, the jam switch contacts close and the BCM receives a door-open input. If the BCM receives a door lock or unlock input, the BCM will activate the inadvertent relay control circuit, providing battery voltage to the inside rearview mirror lamps. The BCM also provides ground to the inside rearview mirror lamps through the courtesy lamp control circuit.
Conditions for Running the DTC
Battery voltage must be between 9-16 volts.
Condition for Setting the DTC
DTC B2555 05 will set when the BCM detects a short to voltage or an open/high resistance in the courtesy lamp control circuit.
Actions Taken When the DTC Sets
When DTC B2555 05 is present, the inside rearview mirror lamps will only operate manually with the inside rearview mirror lamp switches.
Conditions for Clearing the DTC
| • | The condition responsible for setting the DTC no longer exists. |
| • | A history DTC will clear once 100 consecutive malfunction-free ignition cycles have occurred. |
Reference Information
Schematic Reference
Interior Lights Schematics
Connector End View Reference
Component Connector End Views
Description and Operation
Interior Lighting Systems Description and Operation
Electrical Information Reference (Except Opel Gt)
| • | Testing for Intermittent Conditions and Poor Connections |
Scan Tool Reference
Control Module References for scan tool information
Circuit/system Testing
- Ignition OFF, disconnect the harness connector at the inside rearview mirror.
- Connect a test lamp between the appropriate control circuit terminal listed below and B+.
- Command the Courtesy Lamps ON and OFF with a scan tool. The test lamp should turn ON and OFF when changing between the commanded states.
- If all circuits test normal, test or replace the inside rearview mirror.
Repair Instructions
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.
| • | Inside Rearview Mirror Replacement |
| • | Control Module References for BCM replacement, setup, and programming |
