Crankdrive, Cylinder Block
Flywheel
Starter ring gear Before fitting, heat ring gear to 180 °C - 230 °C
Lateral run - out Permissible lateral run - out of installed starter ring gear to flywheel: 0.5 mm
Precision turning Permissible removal of material in clutch disc lining surface area: 0.3 mm
In order to achieve the functional relationship again after removal of material, the same removal of material must take place on the fore part of the flywheel (contact for clutch assembly)
| Dimension A: 2.1 to 2.2 mm | |||
|---|---|---|---|
| .P. A0712.tif | 9 | 14 | tiff;; |