Piston
Type Recessed pistons
Play For short - blocks and cylinder blocks with complete pistons, the clearance is 0.02 to 0.04 mm.
For replacement (oversize), depending on available pistons, a clearance of 0.02 to 0.04.
Home/Opel/Frontera/Opel Frontera A (1992-1998)/Repair manual/OHC Petrol Engine/Technical Data Piston
Contents
Section: OHC Petrol Engine- Modification of Entire Toothed Belt Drive in MY '93
- Modified Adjustment Specification for Automatic Toothed Belt Tension Roller
- Correction of Engine Oil Filling Quantities
- Petrol Engines X20SE and X22XE
- Bearing Bridge and Oil Baffle Plate
- Structural Oil Pan
- Engine - Engine Attaching Parts General
- New X20SE OHC Petrol Engine
- Engine-Specific Characteristic Data (X20SE)
- Illustration - Perspective View, Intake Side (X20SE)
- Illustration - Perspective View, Exhaust Side (X20SE)
- Cylinder Head, Camshaft, Camshaft Drive and Valves (X20SE)
- Engine Block and Crank Drive (X20SE)
- Auxiliary Drive (X20SE)
- Introduction
- Special Service Tools (Engine and Engine Attaching Parts, X20SE/X22XE)
- Illustration C20NE Longitudinal Section
- Safety Measures OHC Petrol Engine C20NE
- How to Check the Compression
- How to Check the Engine Pressure Loss
- How to Measure the Engine Oil Temperature
- How to Check the Oil Pressure
- How to Check and Adjust the Timing
- How to Check and Adjust (With Toothed Belt Tension Roller) the Toothed Belt Tension
- How to Check and Adjust (Without Toothed Belt Tension Roller) the Toothed Belt Tension
- How to Check and Adjust the V-Belt Tension. Alternator
- How to Check and Adjust the V-Belt Tension, Power Steering Pump
- How to Remove and Install the Exhaust Manifold Gasket, Cylinder Head
- How to Remove and Installpф= the Intake Manifold Gasket, Cylinder Head
- How to Remove and Install the Oil Pan Gasket
- How to Remove and Install the Seal Ring, Camshaft Housing Timing Side
- How to Remove and Install the Seal Ring, Camshaft Housing Transmission Side
- How to Remove and Install the Seal Ring, Crankshaft(oil Pump Housing)
- How to Remove and Install the Seal Ring, Camshaft, Rear
- How to Remove and Install the Seal Ring, Thermostat Housing, Cylinder Head
- How to Replace (With Toothed Belt Tension Roller) the Toothed Belt
- How to Replace (Without Toothed Belt Tension Roller) the Toothed Belt
- How to Remove and Install the Rear Toothed Belt Cover (With Toothed Belt Tension Roller)
- Rear Toothed Belt Cover, Remove/install, Without Toothed Belt Tension Roller
- How to Remove and Install the Toothed Belt Tension Roller
- How to Remove and Install the Con-Rod Bearing
- How to Remove and Install the Flywheel
- How to Remove and Install the Piston with Con-Rod
- How to Remove and Install the Bypass Valve
- How to Remove and Install the Cylinder Head Safety Valve
- How to Remove and Install the Oil Filter
- How to Remove and Install the Oil Pump
- How to Remove and Install the Oil Pump Safety Valve
- How to Remove and Install the Camshaft
- How to Remove and Install the Camshaft Housing
- How to Remove and Install the Cylinder Head
- How to Remove and Install the Cam Follower and Valve Lash Adjuster
- How to Clean the Screen (Filter) in Camshaft Housing Cover
- How to Remove and Install the Engine Damping Blocks, Front
- How to Remove and Install the Engine Damping Block, Rear
- How to Remove and Install the Con-Rod
- How to Check for Plane Surface the Cylinder Head
- Cylinder Head, Disassemble and Assemble
- How to Overhaul the Oil Pump
- How to Remove and Install the Piston Ring
- Spark Plug Thread, Recondition
- How to Remove and Install the Starter Ring Gear
- Valve, Grind
- Valve, Grind In
- Valve Guide, Ream
- Valve Seat, Mill
- How to Remove and Install the Engine Without Transmission
- How to Remove and Install the Crankshaft
- How to Check the Crankshaft
- How to Repair Using Short-Block the Engine
- Special Service Tools OHC Petrol Engine C20NE
- Technical Data Engine Oil Viscosity
- Technical Data Engine Oil Quality
- Technical Data Engine Oil Disposal
- Technical Data Engine Oil Filling Capacities
- Technical Data Oil Pump
- Technical Data Adjustment/checking Values
- Technical Data Drive Belts/v-Belts, Alternator
- Technical Data Drive Belts/v-Belts, Power Steering Pump
- Technical Data Drive Belts/toothed Belt
- Technical Data Cylinder Head Gasket
- Technical Data Valves
- Technical Data Valve Dimensions
- Technical Data Camshaft
- Technical Data Grinding Dimensions for Camshaft Bearing
- Technical Data Cylinder Grinding and Piston Dimensions
- Technical Data Cylinder Bore
- Technical Data Piston
- Technical Data Piston Rings
- Technical Data Piston Pins
- Technical Data - Perm. Weight Difference of Con-Rod Without Piston,bearing Shells
- Technical Data Crankshaft Grinding Dimensions
- Technical Data Crankshaft
- Technical Data Starter Ring
- Recommended Torque Values
- Illustration X20SE Perspective View, Intake Side
- Illustration X20SE Perspective View, Exhaust Side
- Illustration X20SE Engine, Longitudinal Section
- Illustration X20SE Engine, Cross Section
- Illustration X20SE Engine Timing
- Safety Measures
- How to Check the Ribbed V-Belt Tension
- How to Check the Engine Oil Pressure
- How to Measure the Engine Oil Consumption
- How to Check the Timing
- How to Adjust the Timing
- How to Check and Adjust the Toothed Belt Tension
- Illustration X20SE Engine Front Side
- Illustration Ribbed V-Belt Routing with Power Steering and AC
- Illustration Toothed Belt Routing
- How to Replace the Ribbed V-Belt
- How to Replace the Ribbed V-Belt Tension Roller
- How to Replace the Toothed Belt
- How to Replace the Toothed Belt Tension Roller
- How to Replace the Front Camshaft Radial Seal Ring
- How to Remove and Install the Rear Toothed Belt Cover
- Illustration Cylinder Head, Camshaft Housing
- Illustration Valve Drive
- Illustration Hydraulic Valve Lifter (Installed)
- Illustration Hydraulic Valve Lifter (Removed)
- How to Replace the Rear Camshaft Housing Gasket
- How to Replace the Gasket, Exhaust Manifold to Cylinder Head
- How to Replace the Intake Manifold Gasket to Cylinder Head
- How to Remove and Install the Heat Sleeve Pipes
- How to Replace the Camshaft Housing
- How to Remove and Install (Cylinder Head Removed) the Camshaft and Cam Follower
- How to Check for Plane Surface the Camshaft Housing
- How to Replace (Cylinder Head Installed) the Hydraulic Valve Lifter
- How to Replace (Cylinder Head Removed) the Hydraulic Valve Lifter
- How to Overhaul the Cylinder Head
- How to Replace the Needle Bearing, Crankshaft
- How to Replace the Front Crankshaft Radial Gasket
- How to Replace the Rear Crankshaft Radial Gasket
- How to Replace the Piston Rings
- How to Replace the Con-Rod Bearing
- How to Replace the Con-Rod
- How to Check for Plane Surface the Cylinder Block
- Oil Filter Replace
- How to Replace the Bypass Valve
- How to Remove and Install the Oil Cooler
- How to Replace X20SE Engine Up to MY'97 the Oil Pan Gasket
- How to Replace X20SE Engine as of MY'97 the Oil Pan Gasket
- How to Check the Oil Pump
- How to Replace the Safety Valve
- How to Replace the Oil Short-Circuit Valve
- How to Check for Leaks (CO Content in Cooling System) the Combustion Chamber
- How to Replace the Seal Ring, Thermostat, Housing/cylinder Head
- How to Remove and Install the Power Steering Pump
- How to Replace the Front Engine Damping Blocks
- How to Replace the Rear Engine Damping Block
- Engine with O Transmission, Remove/install
- How to Assemble the New Short-Block
- Survey of Engine Compartment
- Wiring Harness Routing in Engine Compartment (Schematic)
- Special Service Tools
- Technical Data Oil Disposal
- Technical Data Engine Oil Filling Quantity
- Technical Data Ribbed V-Belt Dimensions
- Technical Data Toothed Belt
- Technical Data Idle Speed, CO Content, Ignition Timing
- Technical Data Con-Rods
- Technical Data Flywheel,
- ABS
- ABS 415
- Accessories
- Additional Lighting
- Air Conditioning
- Airbag
- Antenna
- Anti-Theft Warning System-M
- Battery
- Body Equipment
- Brake Hydraulics, Brake Lines
- Brakes
- Central Door Locking System
- Central Locking with Atws (Electronic)
- Cih Petrol Engine
- Clutch
- Clutch and Transmission
- Cooling System
- Diesel Engine
- Distributor Transmission Four Wheel Drive
- DOHC Petrol Engine
- Electrical Equipment and Instruments
- Electrical Window Winders
- Engine and Engine Aggregates
- Engine Electrics
- Exhaust System
- Fittings, Hinges, Locks
- Frame
- Front Wheel Brake
- Front Wheel Suspension
- Front Wheel Suspension, Wheels and Tyres
- Fuel and Exhaust System
- Fuel Injection Systems
- Fuel System
- Fuse Box
- General Vehicle Information
- Glass, Window Guides, Window Winders
- Headlamps, Lamps and Horn
- Heating, Ventilation
- Heating, Ventilation, Air Conditioning (HVAC)
- Immobiliser
- Instruments, Telltales
- Maintenance, Body and Chassis Sheet Metal Parts, Frame
- Manual Transmission Four Wheel Drive
- OHC Petrol Engine
- Other Accessories
- Paint
- Painting Repair Operations
- Painting Repair System
- Power Steering
- Radiator Grille
- Radio
- Radio Interference Suppression
- Rear Axle and Rear Wheel Suspension
- Rear Axle Four Wheel Drive
- Rear Axle Rear Wheel Drive
- Rear Wheel Brake
- Roof Luggage Carrier (Railing)
- Seats, Upholstery, Inner Trim Panels
- Secondary Air Injection
- Service Brake, Parking Brake
- Sheet Metal Parts (Bolted)
- Sheet Metal Parts (Cement and Seal)
- Sheet Metal Parts (Welded)
- Sliding Roof
- Steering
- Steering Gear
- Steering Linkage
- Steering Wheel - Steering Column
- Switches, Control Unit, Relays, Ignition Lock
- Trailer Hitch
- Trim Panels, Radiator Grille, Spoiler
- Trim Strips, Lettering, Coverings
- Turbo-Charging
- Wheels and Tyres
- Windscreen Wash/wipe System, Heated Screen
- Wiring Harnesses