F0:Data List - Test Step 08 Tp Key Opel Frontera A

Immobiliser Frontera F0:DATA LIST

Ignition "ON"

Disarm immobiliser

Note:

The display on TECH 1 depends on the programming of each immobiliser key fob. The immobiliser control unit recognises whether a valid immobiliser key fob is present, whether the key is programmed, and which of the five available key memories has been programmed in the immobiliser control unit.

Ignition "OFF"

TRANSP. KEY 1

or

TRANSP. KEY 2

or

TRANSP. KEY 3

or

TRANSP. KEY 4

or

TRANSP. KEY 5

OKAY

Note:

NO TRANSP. KEY is displayed if a not programmed immobiliser key fob or a defective immobiliser key fob is used.

NOT PROGR. KEY is displayed if the code of the immobiliser key fob being used is not programmed in the immobiliser control unit.

Important:

Once immobiliser key fobs have been reprogrammed, this parameter value is only updated if communication is interrupted and then reestablished (ignition "OFF" and ignition "ON" again). Otherwise, TECH 1 may indicate NO TRANSP. KEY, even though immobiliser key fobs have been programmed. This fault can only occur when TECH 1 is communicating with the immobiliser control unit.

· Use valid immobiliser key fob or program (register) new immobiliser key fob in immobiliser control unit, see tabel 7, F7: PROGRAMMING

or

· Immobiliser control unit K117 defective

or

· Receiver immobiliser P75 defective (see additional fault diagnosis test step 01).