Home ReviewsRefund
Home/Mazda/Tribute/Mazda Tribute II (2007-2011)/Repair manual/Automatic Trans/Automatic Transaxle Cooling - Tribute Hybrid: Maintenance
Contents Wiring diagrams Section: Automatic Trans All sections

Automatic Transaxle Cooling - Tribute Hybrid: Maintenance Mazda Tribute II

Automatic Trans 2 illustrations

Draining

CAUTIONThe coolant must be recovered in a suitable, clean container for reuse. If the coolant is contaminated, it must be recycled or disposed of correctly.
CAUTIONAlways refill the motor electronics cooling system (MECS) with the same type of coolant that was drained from the system. Do not mix coolant types.

Scheme 742

Scheme 742
Scheme 742

Scheme 743

Scheme 743
Scheme 743
  1. With the vehicle in DRIVE, position it on a hoist. See «LIFTING»(ref-373073-S06960946762010100600000) .
  2. Turn the ignition to the OFF position.
  3. Remove the LH splash shield.
  4. Place a suitable container below the transaxle.
  5. Loosen the hose clamps at the transaxle, then pull the hoses off to allow the coolant to drain.
  6. Connect the hoses to the transaxle and install the hose clamps.
  7. Install the LH splash shield.

More articles — Automatic Transaxle Cooling - Tribute Hybrid