Note. Before you troubleshoot, record all freeze data and any on-board snapshot, and review the general troubleshooting information (see GENERAL TROUBLESHOOTING INFORMATION ).
- Turn the ignition switch to ON (II).
- Clear the DTC with the HDS.
- Start the engine, and let it idle for 10 seconds.
- Check the CMP B NOISE in the DATA LIST with the HDS. Are 0 counts indicated? YES -Go to step 7 . NO -Go to step 5 .
- Test-drive the vehicle for several minutes in the range of these recorded freeze data parameters: ENGINE SPEED VSS
- Check the CMP B NOISE in the DATA LIST with the HDS. Are 0 counts indicated? YES -Go to step 7 . NO -Intermittent failure, the system is OK at this time. Check for poor connections or loose terminals at the CMP sensor and the PCM.
- Check for poor connections or loose terminals at these locations: CMP sensor PCM Engine ground Body ground Are the connections and terminals OK? YES -Go to step 8 . NO -Repair the connections or terminals, then go to step 11 .
- Check for damage on the CMP sensor pulser plate (see «CMP PULSE PLATE REMOVAL AND INSTALLATION»(ref-360277-S29870663222010042800000) ). Is the pulser plate damaged? YES -Replace the CMP sensor pulser plate (see «CMP PULSE PLATE REMOVAL AND INSTALLATION»(ref-360277-S29870663222010042800000) ), then go to step 11 . NO -Go to step 9 .
- Turn the ignition switch to LOCK (0).
- Replace the CMP sensor (see «CMP SENSOR REPLACEMENT»(ref-360284-S25838473272010042800000) ).
- Turn the ignition switch to ON (II).
- Reset the PCM with the HDS.
- Do the PCM idle learn procedure (see «PCM IDLE LEARN PROCEDURE»(ref-360285-S23715037572010042800000) ).
- Start the engine, and let it idle for 10 seconds.
- Check for Pending or Confirmed DTCs with the HDS.
Is DTC P0369 indicated?
YES -Check for poor connections or loose terminals at the CMP sensor and the PCM, then go to step 1 .
NO -Troubleshooting is complete. If any other Pending or Confirmed DTCs are indicated, go to the indicated DTC's troubleshooting.