Parking Aid System - Visual: Removal & Installation Ford Escape III

Installation

1. To install, reverse the removal procedure. Verify camera operation. If the displayed image is inverted, place the ignition ON and leave on for 5 minutes to allow the IPM-B to configure the camera.

Scheme 22

1. NOTE: Module configuration is required when a new IPM-B is being installed. If a new module is being installed, upload the module configuration information from the IPM-B into the scan tool by following the instructions on the scan tool.
2. Remove the LH rear quarter trim panel. Refer to «INTERIOR TRIM AND ORNAMENTATION»(ref-569621) .

1. To install, reverse the removal procedure. If a new module has been installed, download the IPM-B configuration information from the scan tool to the new IPM-B.