Home ReviewsRefund
Home/Buick/Encore/Buick Encore I (2012-2016)/Repair manual/Mechanical/Warm Up Three-Way Catalytic Converter Installation
Contents Wiring diagrams Section: Mechanical All sections

Warm Up Three-Way Catalytic Converter Installation Buick Encore I

Mechanical ~114 words
  1. Install the warm up three way catalytic converter (5) to the brackets and the turbocharger. Use a NEW warm up three way catalytic converter seal (2).
  2. Install a NEW warm up three way catalytic converter V-clamp (1).
  3. Install the 2 catalytic converter to catalytic converter bracket nuts (4) and (6) and hand tighten.
  4. Hand tighten the catalytic converter V-clamp.
  5. Connect the heated oxygen sensor wiring harness (3) to retainer clip.
  6. The catalytic converter V-clamp (1) should be installed in the shown position.
  7. Tighten the catalytic converter to catalytic converter bracket nuts to 22 N.m (16 lb ft).
  8. Tighten the catalytic converter V-clamp to 13 N.m (115 lb in).

More articles — Engine Mechanical - 1.4L (Luj Luv)