Oil Pressure Switch -f22 Audi Q5 I

Removing

Remove the rear engine cover -top arrows-.

Note. To collect escaping engine oil, place a clean cloth under oil filter housing.

Disconnect electrical connector -arrow-.

Remove the oil pressure switch.

Installing

1. Tightening specification, refer to «OIL FILTER HOUSING AND OIL PRESSURE SWITCH OVERVIEW»(ref-515405-S24594246082012120300000) .

Install in reverse order, paying attention to the following

Note. Replace the seal. To prevent coolant loss, insert the new oil pressure switch in the connecting pieces immediately.

Check the oil level.