Fastener Tightening Specifications
| Application | Specification |
|---|
| Metric | English |
| Air Inlet Housing Bolt | 2, 5 Nm | 23 lb in |
| Compressor and Condenser Hose Assembly Bolt | 22 Nm | 16 lb ft |
| Compressor and Condenser Hose Fastener (A20 NHT/LDK) (LAU/28NER) | 20 Nm | 15 lb ft |
| Compressor and Condenser Hose Fastener (LBS/A20DTH) | 22 Nm | 16 lb ft |
| Compressor Bracket Fastener (LDK/A20 NHT) | 22 Nm | 16 lb ft |
| Compressor Bracket Fastener (LAU/A28NER) | 42 Nm | 31 lb ft |
| Compressor Fastener | 22 Nm | 16 lb ft |
| Compressor Hose Fastener | 20 Nm | 15 lb ft |
| Compressor Pressure Relief Valve | 10 Nm | 89 lb in |
| Compressor Tube Assembly Nut | 22 Nm | 16 lb ft |
| Condenser Hose Fasteners | 20 Nm | 15 lb ft |
| Engine Coolant Exhaust Muffler Bracket Fastener | 9 Nm | 80 lb in |
| Engine Coolant Heater Air Supply Hose Retainer | 3, 5 Nm | 31 lb in |
| Evaporator Hose Fastener | 20 Nm | 15 lb ft |
| Evaporator Hose Stud Bolt | 15 Nm | 11 lb ft |
| Evaporator Thermal Expansion Valve Fastener | 7 Nm | 62 lb in |
| Liquid Line to Condenser Fasteners | 22 Nm | 16 lb ft |
| Power Steering Fluid Cooling Pipe Bracket Fastener | 9 Nm | 80 lb in |
| Refrigerant Pressure Sensor | 7, 4 Nm | 66.4 lb in |
Refrigerant System Specifications
| Application | Specification |
|---|
| Metric | English |
| Abrupt refrigerant loss | 60 ml (1) | 2.0 oz (1) |
| When charging system after recovery | 20 ml | 0.7 oz |
| Compressor Replacement The service compressor is shipped with a specified amount of PAG oil. NOTE: Compressor failure can occur if the oil removed during refrigerant recovery is not replaced. |
| Compressor oil (Sanden PXE16) | 110 ml | 3.7 oz |
| Compressor Oil (Delphi SP17) | 150 ml | 5.0 oz |
| Condenser Replacement | 30 ml (2) | 1.0 oz (2) |
| Evaporator Replacement | 40 ml (2) | 1.3 oz (2) |
| Any Line Set (Hose/Tube or Tube Assembly) Replacement | 20 ml (2) | 0.7 oz (2) |
| Total System PAG Oil Capacity - Sanden | 110.0 ml | 3.7 oz |
| Total System PAG Oil Capacity - Delphi | 150 ml | 5.0 oz |
| R-134a |
| Refrigerant Charge (R-134a) | 0.60 kg | 1.5 lb |
| (1) Abrupt refrigerant loss due to large leak, hose rupture, collision, or pressure relief valve opening. Conditions that allow the refrigerant to seep or bleed off over time do not cause this oil loss. Upon replacement of a component that caused a large refrigerant loss, also add the required amount of oil for the particular component. (2) If more than the specified amount of PAG oil was drained from a component, add the amount drained. |
| NOTE |
|---|
| Compressor failure can occur if the oil removed during refrigerant recovery is not replaced. |
| (1) | Abrupt refrigerant loss due to large leak, hose rupture, collision, or pressure relief valve opening. Conditions that allow the refrigerant to seep or bleed off over time do not cause this oil loss. Upon replacement of a component that caused a large refrigerant loss, also add the required amount of oil for the particular component. |
| (2) | If more than the specified amount of PAG oil was drained from a component, add the amount drained. |
