Home ReviewsRefund
Home/Saab/9-3/Saab 9-3 I (1998-2003)/Repair manual/Testing & Diagnostics/DTC P1444 & P1445: EVAP SHUT-OFF VALVE CIRCUIT MALFUNCTION
Contents Wiring diagrams Section: Testing & Diagnostics All sections

DTC P1444 & P1445: EVAP SHUT-OFF VALVE CIRCUIT MALFUNCTION Saab 9-3 I

Testing & Diagnostics ~242 words
  1. Disconnect EVAP shut-off valve harness connector. (Схема №11) Connect SST 86 11 857 test light (Схема №5) or equivalent between EVAP shut-off valve harness connector terminal No. 1 (Green/Red wire) and ground. (Схема №8) If test light illuminates, go to next step. If test light does not illuminate, repair faulty circuit between EVAP shut-off valve harness connector terminal No. 1 and fuse No. 16B (Green/Red wire) located in dashboard fuse block. (Схема №4) See appropriate wiring diagram in «WIRING DIAGRAMS»(ref-3491) article. Go to step 3
  2. Connect test light between EVAP shut-off valve harness connector terminals No. 1 (Green/Red wire) and 2 (Green wire). Connect TECH 2 scan tool to Data Link Connector (DLC). Select ACTIVATE: CANISTER CLOSE VALVE - TRIONIC (100 percent). If test light illuminates, replace EVAP shut-off valve. See «EVAP SHUT-OFF VALVE»(ref-2997-S18120883332000041700000) under FUEL SYSTEM in REMOVAL, OVERHAUL & INSTALLATION article. If test light does not illuminate, repair faulty circuit between EVAP shut-off valve harness connector terminal No. 2 and ECM harness connector No. 37 (Green wire). (Схема №1)for ECM location. (Схема №7)for ECM terminal identification. Go to next step.
  3. Use scan tool to clear all system DTCs. Drive vehicle for 5 minutes under varying loads and engine RPM. Recheck for any stored DTCs. If DTC P1444-P01445 is present, substitute known good ECM and retest system. See «ENGINE CONTROL MODULE (ECM)»(ref-2997-S17585372472000041700000) under COMPUTERIZED ENGINE CONTROLS in REMOVAL, OVERHAUL & INSTALLATION article.

More articles — Engine Controls - Self-Diagnostics - Trionic T7 Fuel Control System