Message Center - Service Information: Maintenance RAM Pickup 2500

RESET OIL CHANGE INDICATOR

After performing the needed maintenance, reset the Oil Change Required indicator using the following procedure

1. Turn the ignition switch to the ON position, but do not start the engine.
2. Fully depress and release the accelerator pedal slowly three times within 10 seconds.
3. Turn the ignition switch to the OFF/LOCK position.

Note. If the Oil Change Required indicator message illuminates when you start the engine, the indicator did not reset. If necessary, repeat this procedure.

RESET PERFORM SERVICE INDICATOR

The Perform Service message will display on the Electronic Vehicle Information Center (EVIC) each time you turn the ignition switch to the ON/RUN position to indicate that emission system scheduled maintenance is required. After performing the scheduled maintenance, reset the Perform Service indicator using the following procedure

1. Turn the ignition switch to the ON position, but do not start the engine.
2. Depress and release the brake pedal two times.
3. Fully depress and release the accelerator pedal slowly two times within 10 seconds.
4. Turn the ignition switch to the OFF/LOCK position.

Note. If the indicator message illuminates when you start the engine, the Perform Service indicator did not reset. If necessary, repeat this procedure.

Scheme 9

The Remote Compass Module (RCM) (2) is a separate stand alone module mounted in the overhead console (1). The RCM can be accessed by removing the overhead console from the vehicle. Some vehicles are equipped with a Universal Garage Door Opener (UGDO) also known as a HomeLink® transceiver. Both the RCM and the HomeLink® transceiver are one in the same and sometimes referred to as the Electronic Overhead Module (EOM).

Scheme 10

The only visible component of the HomeLink® transceiver are the three push buttons (4). The buttons are marked with one, two or three dash marks, respectively, for identification of each channel. For more information on the HomeLink® transceiver, refer to Description .

The RCM or the HomeLink® transceiver cannot be repaired. If ether the compass position sensor or the transceiver is inoperative and requires replacement, the EOM must be replaced as a complete assembly, for the appropriate procedure, refer to MODULE, Compass , Removal .