ECU information available
Actuator test: no OK
Measure parameters: yes
Tooth signal test: no OK
Checks to be carried out if fault is present
| conditions under which the fault appears | checks to be made conditions for checking |
|---|---|
| starting phase engine running | ignition on; engine ECU, disconnected; engine speed sensor, connected: - operate the starter, the voltage varies from 4 V to 9 V between terminals 18 - 46 on the 88 V.NR connector ignition off; engine ECU, disconnected; engine speed sensor, disconnected: - (TU engines): check continuity of wires A and B - (XU engines): check continuity of wires A, B, D, M and - check the direction in which the engine speed sensor is connected (reversal of the wires) - check: sensor resistance value(s) 300 Ω ≤ R ≤ 400 Ω - check the condition of the toothed wheel and the sensor electrode |
Check(s) to be carried out if no fault found
Ignition on; engine ECU, disconnected; engine speed sensor, connected:
Operate the starter; the voltage varies from 4 V to 9 V between terminals 18, 46 on the 88 V.NR connector
Ignition off; engine ECU, disconnected; engine speed sensor, disconnected:
- TU engines: check continuity of wires A and B
- XU engines: check continuity of wires A, B, D and M
Check: no earth at terminal(s) 18 - 46 on the 88 V.NR connector
Check: sensor resistance value(s) 300 ≤ R ≤ 400 Ω
Ignition on; engine ECU, disconnected; engine speed sensor, disconnected:
Check: no voltage at terminal(s) 18 - 46 of the control unit
A TU engines
B XU engines
