Autodiagnostic tester (TAD4.99)
Enables
- Reading the fault codes
- Erasing the fault codes
- The actuator test
Connection to the test connector C1300 - position 1 (coloured green).
Peugeot on-board fault recorder (TEP 92)
Enables
- Fault reading
- The actuator test
- Road testing
- Parameter measurements
- Erasing the faults
Connection to the test connector C1300 (coloured green).
SOURIAU 2690 / SAGEM SAR 860 diagnostic equipment
Enables
- The wiring tests
- The starting test
- Parameter measurements
- Reading the fault codes
- Erasing the fault codes
- The actuator test
Connections: see instructions for use
Peugeot electrical break-out box (B.I.P. 722)
Enables
- Measurements on electrical circuits
- Simulation of component operation
Connection to the control unit 1320
- Connect the adapter (1) to the extension lead (55)
- Disconnect the control unit 1320
- Connect the vehicle harness to the blue adaptor [1]
Depending on the checks to be made, it may be necessary to connect the adaptor to the control unit
Connection to the double relay 1304
- Connect the 2 x 15-way black and white adaptor (3) to the extension lead
- Connect the mauve adapters (4) to both ends of the black adaptor
- Disconnect the double relay and connect it to the black adaptor
- Connect the vehicle harness to the black adaptor
In relation to the checks to be carried out, it may be necessary to disconnect the double relay from the black adaptor
Coded anti-start
Connection to the keypad
- Connect the adapter [OR] to the extension lead ((2))
- Disconnect the keypad 8200 and connect it to the NR connector (15-way) connected to the OR adaptor
- Connect the vehicle harness to the adaptor OR
Tools to be produced locally
Two flying leads (5) 20 cm long fitted with a 5A fuse and 6,35 mm male terminals to short circuit the connector terminals
A flying lead (6) 20 cm long fitted with a 5A fuse and 2,8 mm male terminals to shunt the terminals of the component connectors