Home ReviewsRefund
Home/Opel/Meriva/Opel Meriva A (2003-2011)/Repair manual/OHC Petrol Engine/Special Service Tools
Contents Wiring diagrams Section: OHC Petrol Engine All sections

Special Service Tools Opel Meriva A

OHC Petrol Engine 41 illustrations
KM-194-ESpark Plug Key
To remove/install spark plug
KM-235-DInstaller
Install crankshaft seal ring in conjunction with KM-658
KM-313Slide Hammer
Drive shaft removal in combination with KM-902
KM-412Engine Overhaul Stand
To hold removed engine
KM-412-3Adapter
To hold engine in conjunction with KM-412
KM-417Assembly Sleeve
Installation of oil pump and crankshaft front seal ring
KM-422Installer
To press seal ring in camshaft
KM-468-BHolding Wrench
To counterhold wheel hub when installing axle nut
KM-470-BAngular Torque Wrench
KM-471Adapter
To check pressurised cooling system in conjunction with cooling system tester
KM-498-BOil pressure gauge
To check engine oil pressure
KM-507-CRemover
Pressing out of tie rods
KM-527-AAdjustment pin
Locking transmission shift linkage
KM-558-10Closure Cap
KM-565-ARemover / Installer
Remove and install rocker arms and valve play compensator
MKM-596-ATemperature gauge
To measure oil temperature
KM-604-DTorx Bit and Socket Set
MKM-611Torque Wrench, 3/8"
Range 10 – 60 Nm
MKM-611Torque Wrench, 3/8"
Range 10 – 60 Nm
KM-652Flywheel Holder
To lock flywheel or drive disc
KM-658Installer
To install rear crankshaft seal ring in conjunction with KM-235-1
MKM-669Torque Wrench, 1/2"
Range 50 – 300 Nm
KM-726-AOil Filter Wrench 1/2"
KM-807Closure Plugs
MKM-891Valve compressor
Camshaft removal and installation (cylinder head installed)
KM-902Remover
To remove axle shafts in conjunction with KM-313
KM-904Base Frame
To remove/install engine and transmission with KM-6168
KM-911Flywheel Holder
To lock flywheel or drive disc
KM-947Remover / Installer
Oil dipstick tube
KM-956-1Holding Wrench
KM-2358Wire Cable
To suspend engine
KM-6130Locating Pin
To fasten Ribbed V-belt tensioner
KM-6168Centring Tool
Removal and installation of front axle (with drive unit) in conjunction with KM-904
KM-6169Engine/Transmission Mount
Fixing of engine/transmission to front axle body
KM-6179Installation wrench, oxygen sensor
To remove and install oxygen sensor
KM-6182-1Pliers, straight
Removal/installation of compact clamps
KM-6182-2Pliers, curved
Removal/installation of compact clamps
KM-6182-3Pliers, flexible shaft
Removal/installation of compact clamps
KM--6282Remover
Removal of drive shaft from wheel flange
KM--6283
KM--6347Retaining tool, camshaft timing gears

More articles — Engine and Engine Aggregates