Camshaft Position Sensor Replacement - Exhaust Opel GT II

Camshaft Position Sensor Replacement - Exhaust

Removal Procedure

1. Disconnect the engine wiring harness electrical connector (4) from the exhaust camshaft position (CMP) sensor.
2. Remove the CMP sensor bolt. (Intake CMP shown, exhaust CMP similar)
3. Remove the CMP sensor.

Installation Procedure

1. Inspect the CMP sensor for damage. Replace as necessary.
2. Install the CMP sensor. (Intake CMP shown, exhaust CMP similar)
3. Install the CMP sensor bolt and tighten to 10 N·m (89 lb in).
4. Connect the engine wiring harness electrical connector (4) to the exhaust CMP sensor.