Remove
- 1. Disconnect battery.
- 2. Remove glove compartment • Open glove compartment cover • Unscrew 4x bolt (1) • Disconnect wiring harness plug • Remove glove compartment
- 3. Remove control unit • Cut 2x cable tie (1) on control unit • Disconnect 4x wiring harness plug (2), base holder • Remove control unit – Cut 2x cable tie
Install
- 4. Fit control unit • Connect 4x wiring harness plug • Install control unit – Connect 2x cable tie • Position wiring harness
- 5. Insert glove compartment • Connect wiring harness plug
- 6. Fasten glove compartment • Tighten 4x screw
- 7. Connect battery.
- 8. Function check
- 9. Program volatile memories