Power Windows - Except Evolution: Adjustments Mitsubishi Lancer IX

DOOR WINDOW GLASS ADJUSTMENT

Check that the door moves while contacting the door glass channel when it is raised and lowered fully. If not, adjust the door window according to the following procedures.

1. Remove the door trim and waterproof film. See «DOOR TRIM & WATERPROOF FILM»(ref-169814-S40702715712004121600000) under REMOVAL & INSTALLATION.
2. Loosen the door glass mounting screw via the adjusting hole with the door window glass fully closed, then lower the window glass a little.
3. Fully close the door window glass again and tighten the door glass mounting screw firmly via the adjusting hole.

GLASS SLIDING MECHANISM CHECK AND ADJUSTMENT

If the window glass automatically starts moving downwards at the wrong time while it is being raised, carry out the following adjustment or replacement procedures.

1. Remove the door trim and waterproof film. See «DOOR TRIM & WATERPROOF FILM»(ref-169814-S40702715712004121600000) under REMOVAL & INSTALLATION.
2. Remove the window regulator assembly from the door window glass, and then raise and lower the door window glass by hand to check the operation force.
3. If the door window glass does not move up and down smoothly, check or repair the following points: Check the installation condition of the run channel. Repair any twisting in the door sash. Check the installation condition of the lower sash or the center sash.
4. If repair or adjust is not possible, replace the door assembly.