Home ReviewsRefund
Home/Honda/Odyssey/Honda Odyssey I (1994-1999)/Repair manual/Testing & Diagnostics/DTC P0113 - INTAKE AIR TEMPERATURE (IAT) SENSOR
Contents Wiring diagrams Section: Testing & Diagnostics All sections

DTC P0113 - INTAKE AIR TEMPERATURE (IAT) SENSOR Honda Odyssey I

Testing & Diagnostics ~167 words
  1. Turn ignition on. Check IAT sensor using scan tool. If less than -4°F (-20°C) or less is not indicated, problem is intermittent. Check for poor connections or loose wires in IAT circuit between IAT sensor connector and PCM connector. See «WIRING DIAGRAMS»(ref-16063-S09829279722001010800000) section.
  2. If -4°F (-20°C) or less is indicated, disconnect IAT connector. Install jumper wire between IAT sensor connector terminals. Using scan tool, check intake air temperature. If -4°F (-20°C) or less is not indicated, replace IAT sensor.
  3. If -4°F (-20°C) or less is indicated, turn ignition off. Connect jumper wire between PCM connector terminals D8 and D11. (Схема №4) Turn ignition on. Using scan tool, check intake air temperature. If -4°F (-20°C) or less is not indicated, repair open in wiring between IAT sensor and PCM connector terminals D8 and D11. See «WIRING DIAGRAMS»(ref-16063-S09829279722001010800000) section. If -4°F (-20°C) or less is indicated, substitute a known-good PCM and recheck. If symptom or indication goes away, replace original PCM.

More articles — Engine Controls - Tests W/codes