Home ReviewsRefund
Home/Honda/Odyssey/Honda Odyssey I (1994-1999)/Repair manual/Testing & Diagnostics/DTC P0107 - MAP SENSOR
Contents Wiring diagrams Section: Testing & Diagnostics All sections

DTC P0107 - MAP SENSOR Honda Odyssey I

Testing & Diagnostics ~191 words
  1. Turn ignition on. Check MAP sensor using scan tool. If approximately zero in. Hg is not indicated, problem is intermittent. Check for poor connections or loose wires at 14-pin connector (on right shock tower), MAP sensor connector, and PCM connector. If approximately zero in. Hg is indicated, turn ignition off and disconnect MAP sensor connector.
  2. Turn ignition on. Check MAP sensor using scan tool. If approximately zero in. Hg is not indicated, replace MAP sensor. If approximately zero in. Hg is indicated, measure voltage between MAP sensor connector terminals No. 1 (VCC1) and 2 (SG1). If approximately 5 volts does not exist, repair open in VCC1 circuit between PCM connector terminal D4 and MAP sensor connector terminal No. 1. See «WIRING DIAGRAMS»(ref-16063-S09829279722001010800000) section.
  3. Turn ignition off. Disconnect PCM connector "D". (Схема №4) Measure resistance between MAP sensor connector terminal No. 3 and ground. If continuity exists, repair short in MAP circuit between PCM connector terminal D3 and MAP sensor connector No. 3. See «WIRING DIAGRAMS»(ref-16063-S09829279722001010800000) section. If continuity does not exist, substitute a known-good PCM and recheck. If symptom or indication goes away, replace original PCM.

More articles — Engine Controls - Tests W/codes