Home ReviewsRefund
Home/Honda/Odyssey/Honda Odyssey I (1994-1999)/Repair manual/Testing & Diagnostics/DTC P0108 - MAP SENSOR
Contents Wiring diagrams Section: Testing & Diagnostics All sections

DTC P0108 - MAP SENSOR Honda Odyssey I

Testing & Diagnostics ~285 words
  1. Start engine. Raise and hold engine speed to 3000 RPM with transmission in Park or Neutral, until radiator cooling fan comes on. Let engine idle. Check MAP sensor using scan tool. If MAP sensor reading is not 30.0 in. Hg or more, failure is intermittent. System is okay at this time. Check for poor connections or loose wires at 14-pin connector (on right shock tower), MAP sensor connector, and PCM connector. See «WIRING DIAGRAMS»(ref-16063-S09829279722001010800000) section.
  2. On all models, if MAP sensor reading is 30.0 in. Hg or more, turn ignition off. Disconnect MAP sensor connector. Install jumper wire between MAP sensor harness connector terminals No. 2 and No. 3. Turn ignition on. Check MAP sensor using scan tool. If MAP sensor reading is not 30.0 in. Hg or more, replace MAP sensor. If MAP sensor reading is 30.0 in. Hg or more, turn ignition off.
  3. Remove jumper wire from MAP sensor connector. Turn ignition on. Measure voltage between MAP sensor connector terminals No. 1 (VCC1) and 2 (SG1). If approximately 5 volts exists, turn ignition off and go to next step. If approximately 5 volts does not exist, repair open in SG1 circuit between PCM connector D12 and MAP sensor connector terminal No. 2. See «WIRING DIAGRAMS»(ref-16063-S09829279722001010800000) section.
  4. Install jumper wire between PCM connector terminals D3 (MAP) and D12 (SG1). (Схема №4) Turn ignition on. Check MAP sensor using scan tool. If MAP sensor reading is not 30.0 in. Hg or more, repair open in MAP circuit between MAP sensor and PCM connector terminal D3. If MAP sensor reading is 30.0 in. Hg or more, substitute a known-good PCM and recheck. If symptom or indication goes away, replace original PCM.

More articles — Engine Controls - Tests W/codes