Engine - 2.0L Duratec-He: Component Locations Ford Focus III

Special Tool(s) / General Equipment

Feeler Gauge

Check

1. Refer to: Valve Cover .
2. Measure the clearance of each valve and record its location. A midrange clearance is the most desirable. General Equipment : Feeler Gauge
3. NOTE: The number on the valve tappet reflects the thickness of the valve tappet. For example, a tappet with the number 3.310 has the thickness of 3.31 mm (0.1303 in). NOTE: The number on the valve tappet reflects the thickness of the valve tappet. For example, a tappet with the number 3.310 has the thickness of 3.31 mm (0.1303 in). Intake: 0.23 mm (0.0091 in) - 0.33 mm (0.0130 in). Exhaust: 0.31 mm (0.0122 in) - 0.41 mm (0.0161 in).
4. If any of the valve clearances are out of specification, select new tappets using this formula: tappet thickness = measured clearance + the base tappet thickness - most desirable thickness. Select the tappets and mark the installation location.
5. If any tappets do not measure within specifications, install new tappets in these locations. Refer to: Valve Tappets .

Scheme 195

Scheme 196

Scheme 197

Scheme 198

Scheme 199

Scheme 200

Scheme 201

Scheme 202

1. Refer to: JACKING AND LIFTING - OVERVIEW .
2. Refer to: BATTERY DISCONNECT AND CONNECT .
3. Refer to: AIR CLEANER OUTLET PIPE .
4. Refer to: QUICK RELEASE COUPLING .
5. NOTE: Position back the intake manifold to allow access to disconnect the crankcase ventilation oil separator tube from the intake manifold.