Home ReviewsRefund
Home/Ford/Focus/Ford Focus I facelift (2001-2007)/Repair manual/Communication Devices/Module Configuration: Diagnosis
Contents Wiring diagrams Section: Communication Devices All sections

Module Configuration: Diagnosis Ford Focus I facelift

Communication Devices ~362 words

Inspection and Verification

This service information provides step-by-step module configuration procedures. Carry out the PMI procedures in this article when another service procedure directs to carry out configuration or when DTCs from the below list are present

DTCDescriptionSourceAction
B2477Module Configuration FailureInstrument cluster (IC) Restraints control module (RCM)CARRY OUT PMI. REFER to Programmable Module Installation (PMI) .
P0602Powertrain Control Module Programming ErrorPCMCARRY OUT PMI. REFER to Programmable Module Installation (PMI) .
P0605Internal Control Module Read Only Memory (ROM) ErrorPCMCARRY OUT PMI. REFER to Programmable Module Installation (PMI) .
P1639Vehicle ID Block Corrupted, Not ProgrammedPCMCARRY OUT PMI. REFER to Programmable Module Installation (PMI) .
U0300Internal Control Module Software IncompatibilityPCMCARRY OUT PMI. REFER to Programmable Module Installation (PMI) .
U2050No Application PresentPCMCARRY OUT PMI. REFER to Programmable Module Installation (PMI) .
U2051One or More Calibration Files Missing / CorruptPCMCARRY OUT PMI. REFER to Programmable Module Installation (PMI) .

DIAGNOSTIC TROUBLE CODE (DTC) CHART

Programmable Module Installation (PMI) Using the Integrated Diagnostic System (IDS) When the Original Module is Available

Note. Following module installation, some modules require a separate learning procedure be carried out. For adaptive learning and calibration instructions, refer to the specific module removal and installation procedures.

  1. Connect the IDS and identify the vehicle as normal.
  2. From the Toolbox icon, select Module Programming and press the check mark.
  3. Select Programmable Module Installation.
  4. Select the module that is being replaced.
  5. Follow the on-screen instructions, turn the ignition key to the OFF position, and press the check mark.
  6. Install the new module and press the check mark.
  7. Follow the on-screen instructions, turn the ignition key to the ON position, and press the check mark.
  8. The IDS downloads the data into the new module and displays Module Configuration Complete.
  9. Test module for correct operation.

Programmable Module Installation (PMI) Using the Integrated Diagnostic System (IDS) When the Original Module is NOT Available

Note. Following module installation, some modules require a separate learning procedure be carried out. For adaptive learning and calibration instructions, refer to the specific module removal and installation procedures.

  1. Install the new module.
  2. Connect the IDS and identify the vehicle as normal.
  3. From the Toolbox icon, select Module Programming and press the check mark.
  4. Select Programmable Module Installation.
  5. Select the module that was replaced.
  6. Follow the on-screen instructions, turn the ignition key to the OFF position, and press the check mark.
  7. Follow the on-screen instructions, turn the ignition key to the ON position, and press the check mark.
  8. If the data is not available, the IDS displays a screen stating to contact the As-Built Data Center. Retrieve the data from the technician service publication website at this time and press the check mark.
  9. Enter the module data and press the check mark.
  10. The IDS downloads the data into the new module and displays Module Configuration Complete.
  11. Test module for correct operation.

More articles — Module Configuration