MATERIAL SPECIFICATIONS
| Item | Specification | Fill Capacity |
|---|---|---|
| PAG Refrigerant Compressor Oil (R-134a Systems) YN-12-D | WSH-M1C231-B | Non-hybrid 148 ml (5 fl. oz.) Hybrid 325 ml (11 fl. oz.) |
| R-134a Refrigerant YN-19 (US); CYN-16-P or CYN-16-R (Canada) | WSH-M17B19-A | Non-hybrid 0.71 kg (25 oz.) (1.57 lb) Hybrid 1.08 kg (38 oz.) (2.38 lb) |
| Silicone Gasket and Sealant TA-30 | WSE-M4G323-A4 |
MATERIAL SPECIFICATIONS
TORQUE SPECIFICATIONS
| Description | Nm |
|---|---|
| A/C clutch disc and hub bolt (2.3L, 3.0L [4V]) | 20 |
| A/C clutch disc and hub nut (hybrid) | 26 |
| A/C compressor bolts | 25 |
| A/C compressor discharge fitting nut | 15 |
| A/C compressor manifold bolt (hybrid) | 20 |
| A/C compressor suction fitting nut | 15 |
| A/C pressure relief valve (2.3L, 3.0L [4V]) | 10 |
| Air inlet duct screws | 3 |
| Air inlet mode door actuator screws | 3 |
| Auxiliary coolant flow pump bolts (hybrid) | 4 |
| Auxiliary evaporator inlet line fitting nut (hybrid) | 8 |
| Auxiliary evaporator outlet line fitting nut (hybrid) | 15 |
| Blower motor resistor screws | 3 |
| Blower motor speed control screws | 3 |
| Compressor manifold and tube assembly bracket nut | 8 |
| Condenser bolts | 7 |
| Condenser inlet fitting nut | 15 |
| Condenser outlet fitting nut | 15 |
| Defrost/panel/floor mode door actuator screws | 3 |
| Dual-function pressure switch | 8 |
| Dual-function pressure switch Schrader-type valve | 0.5 |
| Evaporator inlet line bracket nut | 8 |
| Evaporator outlet line fitting nut (hybrid) | 15 |
| Heater core and evaporator core housing nuts | 9 |
| Heater core bracket screw | 3 |
| High-pressure Schrader-type valve | 3.4 |
| High-pressure service gauge port valve cap | 0.8 |
| Low-charge protection switch | 3 |
| Low-charge protection switch Schrader-type valve | 0.5 |
| Low-pressure Schrader-type valve | 2.26 |
| Low-pressure service gauge port valve cap | 0.8 |
| Passenger zone valve bracket nut (hybrid) | 7 |
| Passenger zone valve (tube-O) fittings (hybrid) | 17 |
| Plenum chamber screws | 3 |
| Radiator bracket bolt | 8 |
| Receiver/drier fitting studs | 6 |
| Receiver/drier inlet fitting nut | 15 |
| Receiver/drier nuts (2.3L of 3.0L [4V]) | 8 |
| Receiver/drier nuts (hybrid) | 7 |
| Receiver/drier outlet fitting nut | 15 |
| Temperature blend door actuator screws | 3 |
| Thermal protection switch bolt | 6 |
| Thermostatic Expansion Valve (TXV) bolts | 8 |
| TXV fitting nut | 15 |
| TXV fitting stud | 6 |
TORQUE SPECIFICATIONS
See also:
• JACKING & LIFTING
• SUPPLEMENTAL RESTRAINT SYSTEM